Owner`s manual

Page 34

OPERATING INSTRUCTIONS—TWO TIMER MODELS

1. After loading the dryer with the water washed clothes load,

close the loading door. For better drying, do not load dryer with

combination of garments that twist.

2. Turn the 60-minute drying timer to the desired drying time. The

drying cycle light will be on and indicate the drying. The light

shuts off when drying time is complete. (figure 1 on page 31.)

3. Turn the 15-minute cooling cycle timer to the desired cool down

time. After the drying cycle is completed, then the cooling cycle

time will automatically operate. The cooling light will be on and

indicate the cooling of the clothes load. The light shuts off when

cooling time is completed. (figure 1 on page 31.)

4. Temperature Selector—Select temperature per type of load

being dried in the dryer. (figure 2 on page 26.)

High Heat—Mixed and heavy fabrics, set dial to 195°F

(77°C).

Normal—Cottons and linens, set dial to 170°F (77°C).

Permanent Press Heat—Poly knit synthetics, blends, light-

weight fabrics, set dial to 150°F (66°C).

Low Heat—Delicate, sheer fabrics, easy-to-dry, set dial to

135°F (58°C).

5. Thermometer—Use this with your temperature selection. Note

what temperature is too hot or too cold. (figure 3 on page 31.)

6. Turn switch to “ON” or “I” position. (figure 1 on

page 31.)

7. Close the dryer door, but the basket will not rotate until the

PUSH-TO-START BUTTON is pressed. Press in the PUSH-

TO-START BUTTON (approximately 2 seconds) until the

dryer starts running and then release button. (figure 1 on page

31.)

OPERATING

INSTRUCTIONS—TWO

TIMER MODELS