Specifications

Page 24
S6162-BS-MMC-010/12489
Troubleshooting Chart
TROUBLE CAUSE REMEDY
Replace V-Belt.
Adjust belt tension.
Tighten set screw.
Replace timer
Replace thermostat.
Check timer to see if operating.
Adjust timer (See Furnas control sheet).
Check manual for proper leveling procedures.
Accidental damage to the fan blade can change
the dynamic balance. Damaged fans should be
replaced.
Adjust basket clearance.
Tighten set screws, make sure sheaves are in
proper alignment.
Adjust belt tension.
Occasionally screws, nails, etc. will hand in the
basket perforations and drag against the sweep
sheets surrounding the basket. Such foreign
objects should be removed immediately.
Replace contactor.
Replace motor.
Replace timer.
V-Belt broken.
V-Belt loose.
Motor pulley loose.
Defective timer.
Defective Therm-
O-Cool thermostat.
Reversing timer.
Reversing timer.
Not leveled.
Fan out of balance.
Basket rubbing.
V-Belt sheaves.
Belt.
Foreign objects.
Defective blower
contactor.
Defective motor.
Defective timer.
Basket motor runs, but
basket will not revolve.
Dryer does not stop at
end of cycle.
Basket does not reverse.
Dryer noisy or
vibrating.
Blower motor will not
run (Basket Revolves).
Dryer does not stop at
end of time period.