Specifications

Page 22
S6162-BS-MMC-010/12489
Troubleshooting Chart
TROUBLE CAUSE REMEDY
Reset Overload Relay.
Replace thermostat (Elec. models only)
Check fuses on Circuit Breakers. Make sure
Main Control Switch is on. Check control fuse.
Check power source; voltage, phase and
frequency must be the same as specified on
Electrical Rating Plate.
Replace Switch.
Turn timer clockwise to desired time setting.
Check wire connections in electrical box on rear
of dryer.
Check coils and contacts.
Replace Switch.
Check voltage at motor terminals. Voltage must
be within (plus or minus) 10% of voltage shown
on motor rating plate -- if not, check with local
power company for recommended corrective
measures.
Check with incoming power to ensure that
wiring is adequately sized for load.
Check all electrical connections and tighten any
loose connections.
Check Installation Sheet in Service Manual for
recommended make-up air openings.
Clean lint accumulation on and around motors.
Replace contactor.
Replace timer.
Replace motor.
Motor overloads
open.
Defective Bonnet
Hi-H Limit.
No power.
Incorrect power.
Defective Start
Switch.
Time off.
Loose wiring
connections.
Defective starting
relay.
Defective Door
Switch.
Low voltage.
Inadequate wiring.
Loose connections.
Inadequate air.
Poor housekeeping.
Defective Basket
Motor Contractor.
Defective
Reversing Timer.
Defective motor.
Motor will not start.
Motor tripping on
thermal overload.
Basket motor will not
run.