Owner`s manual

Page 35
Service Savers
To help you troubleshoot the dryer, we list below the most common
reasons for service calls and some answers to the problems.
Before you call service, please review the following items:
DRYER WON'T START
1. Is the door completely closed?
2. Are the controls set to the “on” position?
3. Did you push the “start” control?
4. Has a fuse blown or a circuit breaker tripped?
5. Are the fuses tight?
6. Check for low voltage.
DRYER WON'T HEAT
1. Is the dryer set for “cooling time” rather than “drying
time”?
2. Are the gas valve in the dryer and the valve on the main
gas line turned on?
3. Check for low or intermittant gas pressure.
CLOTHES ARE NOT SATISFACTORILY DRY
1. Timed cycle - Did you allow enough heating time before the
cool-down part of the cycle?
2. Is the lint screen blocked?
3. Is the exhaust duct to the outside clean and not blocked?
(A blocked exhaust will cause slow drying and other
ploblems.)
GAS DRYER IGNITION
Refer to the page on “Instructions for the Direct Ignition
System Operation”. Check to see if the manual gas valve is
open. Then reset the dryer controls. All panels, covers, and
doors must be in place and closed before starting the
dryer.
VERY IMPORTANT
When calling the factory for service, always refer to the
model number, product number and serial number
(found on the rating plate of the dryer).
TROUBLESHOOTING
DRYER WON'T START
DRYER WON'T HEAT
CLOTHES ARE NOT
SATISFACTORILY DRY
GAS DRYER IGNITION