Owner`s manual

Page 34
Operating Instructions - Moisture Control Models (Optional)
OPERATING
INSTRUCTIONS -
MOISTURE CONTROL
MODELS (OPTIONAL)
NOTE:
Machines with Moisture Control option can be used like
regular two-timer models. To dry with Two Timer
method, flip switch on Control Panel to “Time Drying”.
To dry with the Moisture Control method, flip the switch
to “Automatic Drying”. The indicator light will be on
while the machine is in operation.
1. After loading the dryer tumbler with water washed clothes
load, close the loading door. For better drying, do not load
dryer with combination of garments that twist.
2. Select desired Moisture level to remain in “the load from the
selector switch on the Control Panel (see page 26). The
numbers are relative with “10” being the most wet and “0”
being the most dry. After a number of loads have been run and
desired moisture level has been determined, record and reuse
the same setting on similar loads.
3. Turn the 15-minute cooling cycle timer to the desired cool down
time. After the drying cycle is completed, then the cooling cycle
time will automatically operate. The cooling light will be on
and indicate the cooling of the clothes load. The light shuts off
when cooling time is completed. (See page 26.)
4. Temperature Selector - Select temperature per type of load
being dried in the dryer. (See page 23.)
High Heat - Mixed and heavy fabrics, set dial to 195º F (91° C).
Normal - Cottons and linens, set dial to 170º F (77° C).
Permanent Press Heat - Poly knit synthetics, blends,
lightweight fabrics, set dial to 150º F (66° C).
Low Heat - Delicate, sheer fabrics, easy-to-dry, set dial to
135º F (35° C).
5. Digital Temperature Read Out - Use this with your
temperature selection. Note what temperature is too hot or too
cold. (See figure 1 on page 23.)
6. Turn switch to “ON” or “I” position. (See page 26.)
7. Close the dryer door. The basket will not rotate until the
PUSH-TO-START BUTTON is pressed. Press the PUSH-
TO-START BUTTON until the dryer starts running
(approximately 2 seconds) and then release button. (See figure
1 on page 26.)
8. The machine cycle will stop drying and switch to cool-down
when the desired set moisture level has been reached. The
machine will run for the amount of time set on the cool-down
timer.