Owner`s manual

Page 19
Steam Dryers - Installation Instructions
1. The dryer comes in two wood crates:
A - Very large crate
B - Smaller crate
2. Open Crate A and lift dryer off the skid and set in place.
3. Open Crate B. It contains two assemblies:
I - Control Box Assembly
II - Steam Bonnet Assembly
4. Place II - Steam Bonnet Assembly on top of the dryer and
slide piped end to rear of dryer. Bolt to top with six
3/8” ( 10 mm) bolts, flat washers and lockwashers provided.
Attach Solenoid Conduits (2) to the Right Front Control
Box. Then connect the wires as per diagram on the rear
wall of dryer.
5. Place I - Control Box Assembly on top front of the dryer and
bolt in place with six 3/8” (10 mm) bolts, flat washers and
lockwashers. Snap the electrical connections together.
6. Proceed with steam piping, electrical services and duct
work, as specified in technical manual.
STEAM DRYERS -
INSTALLATION
INSTRUCTIONS