Owner`s manual

Page 10
General Installation (All Dryers)
Before operating dryer, open basket door and remove blocking
between front panel and basket. Read the instruction tags,
owner's manual, warnings, etc.
The dryer is so designed that when an operator opens the dryer
door, the basket and exhaust fan stop. You can expect fast
drying from this laundry dryer. Hot, dry air is properly and
effectively moved through the basket and exhausted through a
lint trap to the atmosphere. The dryer comes equipped with an
inclined self-cleaning lint screen. In this system, lint accumu-
lates on the underside of the screen until a blanket of lint will
fall from the screen to the bottom of the dryer cabinet, and
should be removed daily or as required, to prevent an
overaccumulation.
IMPORTANT
Provide adequate clearance for air openings into the
combustion chamber.
Replacement parts for this dryer are available from your dis-
tributor or by contacting the factory at the address or phone
number printed on the cover of this manual.
1. Unscrew two (2) front cover panel hold-down screws and
open the front cover panel. If wires enclosed are not color
coded or numbered, mark wires before disconnecting. Refer
to the wiring diagram.
2. Disconnect the wire plugs in the right and left control boxes.
Unscrew the two (2) hold-down bolts from the bottom of the
boxes and one screw from the outside rear of the boxes.
Remove the two (2) screws that hold the conduit plate to the
boxes. Remove the boxes and the top brace as one assem-
bly.
3. Unscrew the six (6) bolts that hold down the heating unit.
4. Remove the air switch box on the rear of the dryer and
disconnect the two (2) wires and the box from the rear of
the dryer. Leave the air switch fastened to the dryer rear
wall.
5. To re-assemble, reverse this procedure.
GENERAL
IMPORTANT
REPLACEMENT PARTS
PROCEDURE FOR
DISASSEMBLING THE
TOP OF THE DRYER