Owner`s manual

Page 53
OPERATION AND MAINTENANCE
After Start Up
The Gear reducer is shipped filled with oil to the right level and after two
weeks or 100 hours of operation, drain the oil, and flush the gear reducer with
a light flushing oil. The original oil can be used for re-filling if it has been
filtered; otherwise, new oil must be used. After this, change the oil every six
months or 2500 hours of operation.
CAUTION
• USE AGMA 8EP TYPE OIL; CISSELL PART #TU3465
ONLY ! !
. The gear reducer is equipped with two oil plugs located on the right
side as viewed from the back of the dryer.
• To change oil: remove the lower oil plug and drain the used oil.
• Re-install the lower oil plug and remove the upper oil plug. Add
new oil until the oil starts to spill out. Re-install the upper oil plug.
OPERATION AND
MAINTENANCE
Gear Reducer Information