Owner`s manual

Page 50
Basket Alignment—Single Motor Model
BASKET ALIGNMENT
SINGLE MOTOR
MODEL
Step 1 Loosen the set screws on the flange and pillow block bearings.
Step 2 Loosen the 4 side bolts, “1, 2, 3, 4,” on the basket bearing
bracket. (see figure 3) Loosen the two adjusting bolts and
locknuts “5, 6,” inside the bracket. And loosen the bolts “7,” on
the pillow block bearing.
Step 3 Place one “A” and two “B” diameter pins inside the drying
compartment between the rim of the basket opening and the rim
of the door opening in the positions shown in figures 1 and 2.
Check the two “B” pins for equal clearance.
NOTE
Push the basket toward the rear.
Step 4 With the pins in position, tighten the set screws on the bearing
races.
Step 5 Tighten the side bolts “1, 2, 3, 4,” in numerical order. Tighten
the bolts “7” on the pillow block bearing. And tighten the bolts
“5” and locknuts “6”.
Step 6 Remove the aligning pins.
CAUTION
Check to see that the set screws are wrench tight on the bearings.