Manual

5-37
Cisco XR 12404 Router Installation Guide
OL-13830-02
Chapter 5 Maintaining the Router
Removing and Replacing a Consolidated Switch Fabric Card
Figure 5-23 Installing a CSF Card (with PRP-3 installed)
Step 4
Slide the CSF half-way out of the slot, then stop.
Step 5 Touching only the metal card carrier, use your free hand to support the bottom of
the CSF and slide the card completely out of the chassis.
• Always place the CSF directly into an antistatic bag or other ESD-preventive
container.
• If you plan to return the defective CSF to the factory, repackage it in the
shipping container you received with the replacement card.
Step 6 Set both edges of the CSF carrier into the card slot carrier alignment grooves on
either side of the CSF slot and slide the card halfway into the chassis.
Step 7 Pivot the ejector levers outward away from the faceplate.
Step 8 Slide the card into the CSF slot until the ejector levers make contact with the front
of the card cage, then stop.
Step 9 Pivot the ejector levers toward the faceplate until the connector properly seats in
the backplane.
Step 10 Tighten the two captive screws.
Caution Do not overtighten the captive screws; over tightening can strip the
threads on the screw or in the insert in the CSF faceplate.
Step 11 Power on the router.
272403
CONSOLIDATED SWITCH F
ABRIC
CRITICAL
MAJOR
MINOR
MBUS
FAIL
ENABLE
ALARM FABRIC
10
2 3
40C48/POS-SR-SC
TX
RX
ACTIVE
CARRIE
R
RX PKT
CLASS 1 LASER PRODUCT
LASERPRODUKT DER KLASSE 1
PRODUIT LASER DE CLASSE 1
PRODUCTO LASER DE CLASSE 1
CLEAN
CONNECTOR
WITH ALCOHOL
WIPES BEFORE
CONNECTING
ETH 0
ETH 1
BIT
S 0
BI
T
S 1
AUX
CONSOLE
DA
T
A
LINK
D
AT
A
LINK
ACT
SIG
ACT
SIG
RESET
PERFOR
MANCE
RP3
UP
todd.book Page 37 Monday, March 16, 2009 2:47 PM