Specifications

6-7
Cisco XR 12000 Series Router SIP and SPA Software Configuration Guide, Release 3.2
Release 3.2, OL-6396-01, Rev.A1 January 9, 2006
Chapter 6 Configuring POS SPAs on Cisco IOS XR Software
Configuration Tasks
7. ipv4 address ip-address mask
8. exit
9. interface type number
10. ipv4 address ip-address mask
11. pos crc {16 | 32}
12. keepalive [seconds | disable]
13. no shutdown
14. exit
15. Repeat Step 9 through Step 14 for each channel in the group.
16. controller {sonet | preconfigure} number
17. ais-shut
18. no path scrambling disable
19. clock source {internal | line}
20. Repeat Step 16 through Step 19 for each channel of the group.
21. end
or
commit
22. show aps
23. show aps group [number]
Detailed Steps
Command or Action Purpose
Step 1
configure
Example:
RP/0/0/CPU0:router# configure
Enters global configuration mode.
Step 2
aps group number
Example:
RP/0/0/CPU0:router(config)# aps group 1
Adds an APS group with a specified number and enters APS
group configuration mode.
• Use the aps group command in global configuration
mode.
• To remove a group, use the no form of this command,
as in: no aps group number, where the value range is
from 1–255.
Note To use the aps group command, you must be a
member of a user group associated with the proper
task IDs for APS commands.