Specifications

9-2
Cisco XR 12000 Series Router SIP and SPA Software Configuration Guide, Release 3.2
Release 3.2, OL-6396-01, Rev.A1 January 9, 2006
Chapter 9 Command Summary for the POS SPAs
RP/0/0/CPU0:Router(config-if)# ipv4 address
ip-address mask
or
RP/0/0/CPU0:Router(config-if)# ipv6 address
ipv6-prefix/prefix-length
Sets a primary or secondary IP address for an interface.
RP/0/0/CPU0:router(config-if)# keepalive [seconds
| disable]
Sets the keepalive timer for the channel.
RP/0/0/CPU0:router(config-sonet)# loopback
{internal | line}
Configures the SONET controller for loopback.
RP/0/0/CPU0:Router(config-if)# mtu value
Sets the maximum transmission unit (MTU) value for the
interface.
RP/0/0/CPU0:Router(config-if)# no shutdown
Enables an interface.
RP/0/0/CPU0:router(config-sonet)# overhead {j0 |
s1s0e} byte-value
Configures the controller’s overhead.
RP/0/0/CPU0:router(config-sonet)# path keyword
values
Configures SONET controller path values.
RP/0/0/CPU0:router(config-sonet)# path delay
trigger value
Configures SONET port delay trigger values in milliseconds.
RP/0/0/CPU0:router(config-if)# pos crc {16 | 32}
Selects a cyclic redundancy check (CRC) value for the channel.
RP/0/0/CPU0:router(config-if)# ppp authentication
protocol list-name
Enables Challenge Handshake Authentication Protocol (CHAP),
MS-CHAP, or Password Authentication Protocol (PAP) and
specifies the order of selection on the interface.
RP/0/0/CPU0:router# show controllers sonet number
Verifies the SONET controller configuration., where number
specifies the interface ID in the format rack/slot/subslot/port.
RP/0/0/CPU0:router(config-sonet)# threshold
{b1-tca | b2-tca | sd-ber | sf-ber} bit-error-rate
Configures the bit-error rate (BER) threshold values of the
specified alarms for a SONET controller.
RP/0/0/CPU0:router# show aps
Displays operational status for all configured SONET APS
groups.
RP/0/0/CPU0:router# show aps group [number]
Displays operational status for configured SONET APS groups.
RP/0/0/CPU0:Router# show interfaces
Displays the configured interface and checks the status of each
interface port.
RP/0/0/CPU0:Router# show running-config
Displays the configuration information currently running on the
router.
Table 9-1 Command Summary (continued)
Command Purpose