User guide

WVC200-210 User Guide 26
Basic
Configuring Software
• New Time — Allows you to manually enter a new clock setting for the camera.
• Set New Time — Use this button to implement the new date and/or time setting.
• Time Zone — Choose the time zone for your location from the drop-down list.
• Adjust for Daylight Saving Time — Select this option if your location is currently using
Daylight Saving Time.
• Check here if you want to update the time automatically through the NTP Server
on the Internet Enable or disable the time server feature as required. If enabled, the
camera will contact a network time server at regular intervals and update its internal
timer.
• NTP Server Address Enter the address of the NTP Server.
Network Settings
Configuration Type
• Obtain An IP Address Automatically — The camera defaults to this option, allowing a
DHCP server on your network to automatically assign the camera an IP address.
• Fixed IP Address — Use this option to assign a fixed (static) IP address to the camera.
Assign an IP address that is unique to your local network. When using a fixed IP address,
you must configure the IP Address, Subnet Mask, Gateway and DNS.
• IP Address — The IP address assigned to the camera is displayed.
• Subnet Mask — The Subnet Mask assigned to the camera is displayed.
• Gateway — IP address of the gateway router between this device and management
stations that exist on other network segments.
• Primary DNS — The IP address of your ISP’s primary server, which translates the names
of websites into IP addresses.
• Secondary DNS — The IP address of your ISP’s secondary server, which translates the
names of websites into IP addresses.
NOTE: You must uncheck the Adjust for Daylight Saving
Time check box manually when Daylight Saving Time
ends in your time zone.
NOTE: If connecting to a router, it may be necessary to
enable port forwarding.