Installation guide

38 Release Notes for Catalyst 6000 Family Software Release 5.x

Documentation Updates for Software Release 5.2

• The show qos acl map command syntax is documented incorrectly in the QoS chapter of the

Catalyst 6000 Family Software Conﬁguration Guide, Software Release 5.3. It is:

show qos acl map {conﬁg | runtime} {acl_name | mod_num/port_num | vlan | all}

See the online version of the Catalyst 6000 Family Command Reference, Software Release 5.3

publication for complete information about the syntax.

• The show qos maps command syntax is documented incorrectly in the QoS chapter of the

Catalyst 6000 Family Software Conﬁguration Guide, Software Release 5.3. It is:

show qos maps {conﬁg | runtime} [cos-dscp-map | ipprec-dscp-map | dscp-cos-map |

policed-dscp-map]

See the online version of the Catalyst 6000 Family Command Reference, Software Release 5.3

publication for complete information about the syntax.

• In the QoS chapter of the Catalyst 6000 Family Software Conﬁguration Guide, Software Release

5.3, in the “Displaying QoS Information” section, the example command is with the conﬁg

keyword, not the runtime keyword.

• The QoS chapter of the Catalyst 6000 Family Software Conﬁguration Guide, Software Release

5.3, does not include the WRED thresholds defaults, which are: queue type is tx, threshold 1 is

80 percent, threshold 2 is 100 percent, and the low threshold is picked automatically by the

system.

Documentation Updates for Software Release 5.2

This section describes caveats for the Catalyst 6000 family software release 5.2 documentation.

These changes will be included in the next update to the documentation.

• Some publications incorrectly document the model number of the 48-Port 10/100TX RJ-21 Ethernet

switching module. The model number is

WS-X6248-TEL.

• The Catalyst 6000 family Module Installation Guide incorrectly states that the 48-Port 10/100TX

RJ-21 Ethernet switching module (

WS-X6248-TEL) interfaces can use either Category 3 or

Category 5 UTP cable. The WS-X6248-TEL module RJ-21 connectors do not support Category

3 RJ-21 Telco connectors and cabling. Using Category 3 connectors and cabling causes carrier

sense errors. You must use Category 5 RJ-21 Telco connectors and cables with the

WS-X6248-TEL module.

• The Catalyst 6000 and 6500 Series Quick Software Conﬁguration, Software Release 5.2

publication incorrectly documents the set port channel command syntax. The command syntax

is:

set port channel mod_num/port_num mode {on | off | desirable | auto} [silent |

non-silent]

• Refer to the Catalyst 6000 and 6500 Series Software Conﬁguration Guide, Software Release 5.2,

for information about the set gvrp applicant command. This command is not in the Catalyst

6000 and 6500 Series Command Reference, Software Release 5.2.

• The Catalyst 6000 and 6500 Series Command Reference, Software Release 5.2 publication

contains a Usage Guideline that incorrectly limits the set port negotiation command to Gigabit

Ethernet ports. The command is usable on all ports.

• The “Egress Port Scheduling” section on page 9-5 of the Catalyst 6000 and 6500 Series Software

Conﬁguration Guide, Software Release 5.2, incorrectly describes allocation of bandwidth

between the transmit queues. QoS allocates buffers, not bandwidth.