Specifications

5-15
Catalyst 6500 Series Switch and Cisco 7600 Series Router Network Analysis Module Installation and Configuration Note
78-16413-01
Chapter 5 Troubleshooting the Network Analysis Module
Supported MIB Objects
Step 1 Access the NAM CLI.
Step 2 Enter these commands:
web-user
user name
name
exit
Step 3 At the prompt, enter the new password.
Step 4 Enter Y to confirm the new password.
When the NAM TACACS+ setting is misconfigured and a local database user account is not
available to fix this problem from the web interface, you may be able to fix the TACACS+
configuration by using the CLI interface.
To recover the passwords, follow these steps:
Step 1 Access the NAM CLI.
Step 2 Enter this command:
ip http tacacs+ enable tacacs+ server
Step 3 Follow the commands to enter the TACACS+ secret key.
Supported MIB Objects
Table 5-4 lists the RMON and RMON2 MIB objects supported by the supervisor engine and the NAM.
The supervisor engine implements some objects from the RMON MIBs as specified in Table 5-4. The
supervisor engine RMON implementation is completely independent of the NAM implementation, and
no MIB objects are shared.
To collect etherStats from a physical interface on the switch, configure the etherStatTable on the
supervisor engine instead of on the NAM. The etherStats are collected accurately on multiple physical
interfaces simultaneously.
If you are interested in the etherStats for a specific VLAN, configure the etherStatsTable on the NAM.
For the data source, use the ifIndex corresponding to that VLAN.
Any alarmVariable configured on the supervisor engine must reference a MIB object on the supervisor
engine. An alarmVariable configured on the NAM must reference a MIB object on the NAM.
Note You cannot configure an alarmVariable on the NAM that references a MIB object on the supervisor
engine or configure an alarmVariable on the supervisor engine that references a MIB object on the NAM.