Specifications

5-8

Catalyst 6500 Series Switch and Cisco 7600 Series Router Network Analysis Module Installation and Configuration Note

78-16413-01

Chapter 5 Troubleshooting the Network Analysis Module

Error Messages

Symptom When a reset command is entered from the supervisor CLI, the system always boots into the

maintenance image.

Possible Cause If the boot device is configured in the supervisor engine as cf:1, typing a reset

module command always boots to the maintenance image.

Recommended Action Override the configured boot device in the supervisor engine by entering the

boot string during reset.

• In Cisco IOS software, to boot to the application image, use the hw-module mod 9 reset hdd:1

command.

• In Catalyst operating system software, to boot to the application image, use the reset 9 hdd:1

command.

NDE version

8-Prefix-Aggregation

• Monitor > Apps displays “Others” only.

• Monitor > Host displays data as subnets (as well as 0.0.0.0).

The detail popup window displays no data.

• Monitor > Conversation displays data (as well as 0.0.0.0 to

0.0.0.0). Detail popup window displays no data.

• Support NetFlow custom data sources that are set up for

specific interfaces.

• No DiffServ other than TOS 0 and DSCP 0.

NDE version

8-Source-Prefix-Aggregation

• Monitor > Apps displays “Others” only.

• Monitor > Host displays data with subnets (as well as 0.0.0.0).

The detail popup window displays no data.

• Monitor > Conversation displays data with subnets to 0.0.0.0

(as well as 0.0.0.0 to 0.0.0.0). Detail popup window displays no

data.

• Support NetFlow custom data sources that are set up for

specific interfaces.

• No DiffServ other than TOS 0 and DSCP 0.

NDE version 8-AS-Aggregation Not supported.

Table 5-3 Effects on Data Collection Screens (continued)

Flow Effect