Specifications

4-18
Catalyst 6500 Series Switch and Cisco 7600 Series Router Network Analysis Module Installation and Configuration Note
78-16413-01
Chapter 4 Administering the Network Analysis Module
Catalyst Operating System Software
Trying 127.0.0.31 ... Open
Cisco Maintenance image
login: root
Password:
Maintenance image version: 2.1(0.7)
[e-mail]# upgrade ftp://namlab-pc1/pub/rmon/nam-app.3-3-0-15.bin.gz
Downloading the image. This may take several minutes...
ftp://namlab-pc1/pub/rmon/nam-app.3-3-0-15.bin.gz (58699K)
/tmp/upgrade.gz [########################] 58699K | 6499.18K/ss
60108348 bytes transferred in 9.03 sec (6499.05k/sec)
Upgrade file ftp://namlab-pc1/pub/rmon/nam-app.3-3-0-15.bin.gz is downloaded.
Upgrading will wipe out the contents on the storage media.
Do you want to proceed installing it [y|N]: y
Proceeding with upgrade. Please do not interrupt.
If the upgrade is interrupted or fails, boot into
Maintenance image again and restart upgrade.
Creating NAM application image file...
Initializing the application image partition.
This process may take several minutes...
Applying the image, this process may take several minutes...
Performing post install, please wait...
Application image upgrade complete. You can boot the image now.
[e-mail]#
Console> (enable) reset 3
This command will reset module 3.
Unsaved configuration on module 3 will be lost
Do you want to continue (y/n) [n]? y
ResetPcBlade:start shutdown module 3
SendShutDownMsg - proc_id (1):shut down PC success.
Module 4 shut down in progress, please don't remove module until shutdown completed.
Console> (enable) 2004 May 07 23:19:03 %SYS-5-MOD_OK:Module 4 is online
Upgrading the NAM Maintenance Software with Catalyst Operating System Software
To upgrade the NAM maintenance software, follow these steps:
Step 1 Copy the NAM maintenance software image to a directory that is accessible to FTP.
Step 2 Log into the switch through the console port or through a Telnet session.
Step 3 If the NAM is running in the application image, go to Step 4. If the NAM is not running in the
application image, enter this command in privileged mode:
Console> (enable) reset mod
Step 4 After the NAM is back online, establish a console session with the NAM and log into the root account.
Step 5 Upgrade the NAM maintenance software as follows:
root@localhost# upgrade ftp-url