Specifications

4-15
Catalyst 6500 Series Switch and Cisco 7600 Series Router Network Analysis Module Installation and Configuration Note
78-16413-01
Chapter 4 Administering the Network Analysis Module
Catalyst Operating System Software
To enable a full memory test, use the set boot device bootseq mod# mem-test-full command. This
example shows how to do a full memory test:
Console (enable) set boot device cf:1 4 mem-test-full
Device BOOT variable = cf:1
Memory-test set to FULL
Warning:Device list is not verified but still set in the boot string.
Console> (enable) show boot device 4
Device BOOT variable = cf:1
Memory-test set to FULL
When you next reset the NAM, the full memory test runs.
This example shows how to reset the partial memory test:
Console> (enable) set boot device cf:1 4
Device BOOT variable = cf:1
Memory-test set to PARTIAL
Warning:Device list is not verified but still set in the boot string.
Console> (enable)
Console> (enable) show boot device 4
Device BOOT variable = cf:1
Memory-test set to PARTIAL
To reset the module from the CLI, perform this task in privileged mode:
This example shows how to reset the NAM that is installed in slot 9:
Router# reset 9 hdd:1
Proceed with reload of module? [confirm] y
% reset issued for module 9
Note For the boot device, you can specify hdd:1 for the application image or cf:1 for the maintenance image.
Router#
00:26:55:%SNMP-5-MODULETRAP:Module 9 [Down] Trap
00:26:55:SP:The PC in slot 8 is shutting down. Please wait ...
Software Image Task Command
Maintenance Image Reset the module. hw-module module mod_num reset device:partition
[mem-test-full]
The device:partition value is the string for the PC boot
device; for exampl, hdd:1 designates the hard disk and cf:1
designates the compact Flash where x is the number for the
partition on each device.
Application Image Reset the module. hw-module module mod_num reset device:partition
[mem-test-full]
The device:partition value is the string for the PC boot
device; for example, hdd:1 designates the hard disk and
cf:1 designates the compact Flash where x is the number for
the partition on each device.