Specifications

vii

Catalyst 6500 Series Switch and Cisco 7600 Series Router Network Analysis Module Installation and Configuration Note

78-16413-01

Preface

Product Numbers:

WS-SVC-NAM-1

WS-SVC-NAM-2

This publication describes how to install the Catalyst 6500 series switch, Catalyst 6000 series switch, or

Cisco 7600 series router Network Analysis Module (NAM) running NAM software release 3.3(1) and

how to configure the NAM using the command-line interface (CLI) for the operating system supporting

your NAM (Cisco IOS or the Catalyst operating system).

You can also use the NAM Traffic Analyzer application to configure the NAM. The traffic analyzer

online help and user guide describe its use.

See the “Related Documentation” section on page xiv for more information about software

configuration.

Note For translations of the warnings in this publication, see the “Safety Overview” section on page ix and

refer to the Regulatory Compliance and Safety Information for the Catalyst 6500 series switch, Catalyst

6000 series switch, or Cisco 7600 series router.

Note Third-party software used under license accompanies the Network Analysis Module software, Release

3.3. Notices that may apply to the license and to the use of such third-party software are listed in the

Audience

Only trained and qualified service personnel (as defined in IEC 60950 and AS/NZS3260) should install,

replace, or service the equipment described in this publication.