Specifications

4-5
Catalyst 6500 Series Switch and Cisco 7600 Series Router Network Analysis Module Installation and Configuration Note
78-16413-01
Chapter 4 Administering the Network Analysis Module
Cisco IOS Software
Note When specifying the boot device for the WS-X3860-NAM, you must use hdd:1 for the application image
or hdd:2 for the maintenance image. When specifying the boot device for the WS-SVC-NAM-1 and the
WS-SVC-NAM-2, you must use hdd:1 for the application image and cf:1 for the maintenance image.
Upgrading the NAM Software with Cisco IOS Software
You can upgrade both the application software and the maintenance software. To upgrade the application
software, see the “Upgrading the NAM Application Software with Catalyst Operating System Software”
section on page 4-17. To upgrade the maintenance software, see the “Upgrading the NAM Maintenance
Software with Catalyst Operating System Software” section on page 4-18.
The NAM application and maintenance images are not interchangeable.
Table 4-2 lists the NAM image prefixes.
Upgrading the NAM Application Software with Cisco IOS Software
To upgrade the NAM application software, follow these steps:
Step 1 Copy the NAM application software image to a directory accessible to FTP.
Step 2 Log in to the switch through the console port or through a Telnet session.
Step 3 If the NAM is running in the maintenance image, go to Step 4. If the NAM is not running in the
maintenance image, enter this command in privileged mode:
Router# hw-module module 9 reset cf:1
Device BOOT variable for reset = cf:1
Warning:Device list is not verified.
Proceed with reload of module? [confirm]
% reset issued for module 9
Router#
00:03:31:%SNMP-5-MODULETRAP:Module 9 [Down] Trap
00:03:31:SP:The PC in slot 9 is shutting down. Please wait ...
00:03:41:%SNMP-5-COLDSTART:SNMP agent on host R1 is undergoing a cold
start
00:03:46:SP:PC shutdown completed for module 9
00:03:46:%C6KPWR-SP-4-DISABLED:power to module in slot 9 set off (admin
request)
00:03:49:SP:Resetting module 9 ...
00:03:49:%C6KPWR-SP-4-ENABLED:power to module in slot 9 set on
00:05:53:%SNMP-5-MODULETRAP:Module 9 [Up] Trap
00:05:53:%DIAG-SP-6-BYPASS:Module 9:Online Diagnostics is Bypassed
00:05:53:%OIR-SP-6-INSCARD:Card inserted in slot 9, interfaces are now
online
Router#
Table 4-2 NAM Image Prefixes
Module Application Image Maintenance Image
WS-SVC-NAM-1 nam-app c6svc-nam-maint
WS-SVC-NAM-2 nam-app c6svc-nam-maint