Specifications

4-2

Catalyst 6500 Series Switch and Cisco 7600 Series Router Network Analysis Module Installation and Configuration Note

78-16413-01

Chapter 4 Administering the Network Analysis Module

Cisco IOS Software

Table 4-1 shows the user levels and passwords for the NAM.

Note The guest account in the NAM maintenance image has all read and all write privileges.

When you boot into either the application image or the maintenance image and set up IP information,

that information is synchronized between the images. If you change passwords, that information is not

synchronized between the images and is not reflected on the unchanged image.

To allow remote Telnet sessions, use the exsession on command. SSH also can be used to log into the

NAM. You must install the crypto patch to use this feature. To enable SSH on the NAM, use the

exsession on ssh command.

To log in to the NAM, follow these steps:

Step 1 Log in to the switch using the Telnet connection or the console port connection.

Step 2 At the CLI prompt, establish a console session with the NAM using the session slot slot_number

processor 1 command, as follows:

Router# session slot 8 processor 1

The default escape character is Ctrl-^, then x.

You can also type 'exit' at the remote prompt to end the session

Trying 127.0.0.81 ... Open

Cisco Network Analysis Module (WS-SVC-NAM-1)

Step 3 At the NAM login prompt, type root to log in as the root user or guest to log in as a guest user.

Step 4 At the password prompt, enter the password for the account. The default password for the root account

is “root” and the default password for the guest account is “guest.”

Password:

After a successful login, the command line prompt appears as follows:

Network Analysis Module (WS-SVC-NAM-1) Console, 2.1(1)

WARNING! Default password has not been changed!

root@localhost#

Table 4-1 NAM Users and Passwords

Module Application Image (located on the hard disk) Maintenance Image (located on the compact flash)

WS-SVC-NAM-1

WS-SVC-NAM-2

User Password User Password

root root root cisco

guest guest guest cisco