User manual

Release Notes for Catalyst 6500 Series Content Switching Module Software Release 2.2(8)

78-12569-16

Caveats

Workaround: None.

Open Caveats in Release 2.2(6)

This section describes known limitations that exist in CSM software release 2.2(6).

• CSCdw84018

Release 2.2(x) does not support RTSP UDP streaming when a client NAT is enabled. If this

configuration is set up, the server attempts to open a UDP connection. Some RTSP clients then fall

back on interleaved mode (inline TCP). This mode will work in the application software, although

the connection is sent to fastpath.

Workaround: None

• CSCdw49073

The CSM does not support creating more than 127 virtual servers with the same virtual IP (VIP)

address, even though the CLI does allow you to configure more than 127 virtual servers. If you use

the CLI to configure more than 127 virtual servers, the 128th and subsequent virtual servers will not

function properly.

Workaround: Do not configure more than 127 virtual servers on the same VIP.

• CSCdv00464

Issuing the clear interface gigabit slot/port command for a CSM gigabit port may not clear the

counters.

Workaround: None.

• CSCdv11685

You cannot configure different fault-tolerant pairs to use the same fault-tolerant VLAN.

Workaround: Use a different fault-tolerant VLAN for each fault-tolerant CSM pair.

• CSCdv29125

In firewall configurations using an HTTP 1.1 redirect virtual server, a connection going through the

firewalls may remain open after a redirect virtual server connection is established.

Workaround: None. This connection closes when it times out.

• CSCdu57891

The output from the show interface gigabit slot/port command may erroneously indicate that one

or more of the CSM gigabit ports are down.

Workaround: Disregard the display.

• CSCdu82478

In CSM software release 2.x, it is important that packets transmitted from the CSM toward a client

(server) are transmitted on the same VLAN as packets received by the CSM from that same client

(server). This constraint may be satisfied as follows:

–

Multiple routes on the CSM to the same destination are supported, but all such routes need to

go through gateways on the same VLAN. Ensure that all routes to any particular destination go

through the same VLAN. For example, the following configuration is invalid because it is

possible for traffic from a remote source to arrive on both VLAN 10 and VLAN 20:

Router(config)# module csm 4

Router(config-module-csm)# vlan 10 client

Router(config-slb-vlan-client)# gateway 1.1.1.1