Datasheet

Data Sheet
All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 12 of 15
●
WS-X4232-GB-RJ: Cisco Catalyst 4500 32-Port 10/100 (RJ-45), 2-Gigabit Ethernet (GBIC)
module
●
WS-X4302-GB: Cisco Catalyst 4500 Gigabit Ethernet Module, 2 ports (GBIC)
●
WS-X4306-GB: Cisco Catalyst 4500 Gigabit Ethernet Module, 6 ports (GBIC)
●
WS-X4506-GB-T: Cisco Catalyst 4500 Gigabit Ethernet Module, 6 ports 10/100/1000
802.3af PoE or 1000BASE-X (SFP)
●
WS-X4418-GB: Cisco Catalyst 4500 Gigabit Ethernet Module, server switching 18 ports
(GBIC)
●
WS-X4448-GB-SFP: Cisco Catalyst 4500 Gigabit Ethernet Module, 48 ports 1000BASE-X
(optional SFPs)
●
WS-X4424-GB-RJ45: Cisco Catalyst 4500 24-Port 10/100/1000 Module (RJ-45)
●
WS-X4448-GB-RJ45: Cisco Catalyst 4500 48-Port 10/100/1000 Module (RJ-45)
●
WS-X4548-GB-RJ45: Cisco Catalyst 4500 Enhanced 48-Port 10/100/1000 Module (RJ-45)
●
WS-X4524-GB-RJ45V: Cisco Catalyst 4500 PoE 802.3af 10/100/1000, 24 ports (RJ-45)
●
WS-X4548-GB-RJ45V: Cisco Catalyst 4500 PoE 802.3af 10/100/1000, 48 ports (RJ-45)
Optics Support
The two GBIC ports directly on the Cisco Catalyst 4500 Series Supervisor II-Plus module support
the following GBIC media types:
●
WS-G5483: Cisco 1000BASE-T GBIC
●
WS-G5484: Cisco 1000BASE-SX Short-Wavelength GBIC (multimode only)
●
WS-G5486: Cisco 1000BASE-LX/LH Long-Haul GBIC (single-mode or multimode)
●
WS-G5487: Cisco 1000BASE-ZX Extended-Reach GBIC (single-mode)
●
Cisco coarse wavelength-division multiplexing (CWDM) GBIC solution
Software Requirements
The minimum software version is Cisco IOS Software Release 12.2(25)SG or later for the Cisco
Catalyst 4503 Catalyst 4506 chassis. The minimum software version is Cisco IOS Software
Release 12.2(37)SG or later for the Catalyst 4503E and Catalyst 4506E chassis. The minimum
software version is Cisco IOS Software Release 12.2(40)SG or later for the Catalyst 4507R and
Catalyst 4510R chassis.
Indicator and Port Specifications
●
System status: Green (operational)/red (faulty)
●
Switch usage load: 1 to 100 percent aggregate switching usage
●
Console: RJ-45 female
●
Reset (switch recessed protected)
●
Uplinks: Link and active
●
Image management port: 10/100BASE-TX (RJ-45 female) data terminal equipment (DTE);
green (good), orange (disabled), off (not connected)