Specifications

9
Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine II-Plus TS
78-16551-01
Supervisor Engine II-Plus TS
LEDs
Table 1 describes the LEDs on the supervisor engine front panel.
SFP Ports
The Gigabit Ethernet SFP ports operate in full-duplex mode only. These ports use the 1000BASE-SX,
1000BASE-LX, Cisco Coarse Wave Division Multiplexing (CWDM ) SFPs, 1000BASE-T SFP, and
1000BASE-ZX SFP. SFP connectors vary with interface type and may use multimode fiber (MMF),
single-mode fiber (SMF) cable, or copper Ethernet cables. For further information on SFPs, see the “SFP
Guidelines” section on page 16.
10/100/1000 Ports
The 10/100/1000 ports operate in full-duplex mode or in half-duplex mode. These ports use RJ-45
connectors.
Ethernet Management Port
The Ethernet management port is used (in ROMMON mode only) to recover a switch software image
that has been corrupted or destroyed. This port is not active while the switch is operating normally.
Table 1 Supervisor Engine LEDs (WS-X4013+TS)
LED LED Status Description
STATUS Indicates the results of a series of self-tests.
Green All diagnostic tests passed.
Red A test failed.
Orange System boot or diagnostic test is in progress.
Off Module is disabled.
UTILIZATION Green 1–100% If the switch is operational, this display indicates the
current traffic load over the backplane (as an approximate
percentage).
Link Indicates the status of the 10/100BASE-T Ethernet
management port or uplink ports.
Green The link is operational.
Orange The link is disabled by user.
Flashing orange The power-on self-test indicates a faulty port.
Off No signal is detected, or there is a link configuration
failure.
PoE Status Green
Off
Red
PoE is healthy.
No PoE power is available.
One or more ports are in power-deny mode.