Technical information

9
IPSec VPN Acceleration Services Module Installation and Configuration Note
78-14459-03 Rev C0
Front Panel Description
Note The FlexWAN module and the Optical Services Modules (OSMs) are not supported by Cisco
IOS Release 12.2(9)YO4.
Support for the FlexWAN module is added with Cisco IOS Release 12.2(14)SY (see the
“Supported Features in Release 12.2(14)SY” section on page 6 for a complete list of
supported port adapters). OSMs are not supported by Cisco IOS Release 12.2(14)SY.
Front Panel Description
The LED on the VPN module front panel (see Figure 2) indicates the status of the module. Table 1
describes the LED operation.
Figure 2 VPN Module Front Panel
Table 1 VPN Module LED Description
LED Color/Description
STATUS The STATUS LED shows the status as follows:
• Normal initialization sequence
Orange—Module is booting or running diagnostics
Green—All diagnostics pass; module is operational
• Fault during initialization sequence
Orange—Module is booting or running diagnostics
Red—Diagnostic test fails; module is not operational
• Environmental monitoring
Orange—Overtemperature condition (minor threshold exceeded)
Red—Overtemperature condition (major threshold exceeded)
STATUS
77113
STATUS LED
IPSec VPN Acceleration Services Module
WS-SVC-IPSEC-1