Technical information

7
IPSec VPN Acceleration Services Module Installation and Configuration Note
78-14459-03 Rev C0
Hardware and Software Requirements
– PA-MC-2T1: 2-port multichannel T1
– PA-MC-8T1: 8-port multichannel T1
– PA-MC-T3: 1-port multichannel T3
– PA-MC-E3: 1-port multichannel E3
– PA-A3-T3: T3 ATM
– PA-A3-OC3MM: OC3 ATM multimode
– PA-A3-OC3SMI: OC3 ATM single-mode IR
– PA-A3-OC3SML: OC3 ATM single-mode LR
– PA-POS-OC3MM: OC3 POS multimode
– PA-POS-OC3SMI: OC3 POS single-mode IR
– PA-POS-OC3SML: OC3 POS single-mode LR
– PA-H: 1-port HSSI
– PA-2H: 2-port HSSI
• You may have a VPN module in the same chassis with the following service modules:
– Firewall Services Module (WS-SVC-FWM-1-K9)
– Intrusion Detection System Module 2 (WS-SVC-IDS2BUNK9)
– Network Analysis Module 1 (WS-SVC-NAM-1), Network Analysis Module 2
(WS-SVC-NAM-2)
Note You can install a maximum of four service modules of any one kind per chassis (such as four
Firewall Services Modules and four Network Analysis Modules per chassis). The exception is
the Intrusion Detection System Module 2 (IDSM2); you can only install two IDSM2s per
chassis.
Hardware and Software Requirements
This section describes the hardware and software requirements for the VPN module.
Software Requirements
This section lists the software requirements for the VPN module:
• Cisco IOS Release 12.2(9)YO4 or later releases
• Cisco IOS Release 12.2(14)SY or later releases