Technical information

48
IPSec VPN Acceleration Services Module Installation and Configuration Note
78-14459-03 Rev C0
Configuring a VPN Using the VPN Module
!
interface GigabitEthernet5/1
no ip address
flowcontrol receive on
flowcontrol send off
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,101,1002-1005
switchport mode trunk
cdp enable
!
interface ATM6/0/0
no ip address
atm clock INTERNAL
!
interface ATM6/0/0.101 point-to-point
pvc 1/101
!
crypto connect vlan 101
!
interface Vlan101
ip address 192.168.101.1 255.255.255.0
no mop enabled
!
Crypto Connection for a POS Port Adapter in the FlexWAN Module
The configuration for this example is as follows:
• The FlexWAN module is in slot 6.
• The POS port adapter is in bay 1.
• The VPN module is in slot 5.
• VLAN 16—pos6/1/0.16
!
frame-relay switching
!
!
interface GigabitEthernet5/1
no ip address
flowcontrol receive on
flowcontrol send off
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,16,1002-1005
switchport mode trunk
cdp enable
!
interface POS6/1/0
no ip address
encapsulation frame-relay
!!!
!!! The peer POS interface config does not need
!!! to have the following two lines.
!!!
no keepalive
clock source internal
frame-relay intf-type dce
!
interface POS6/1/0.16 point-to-point
no cdp enable
frame-relay interface-dlci 16