Technical information

20
IPSec VPN Acceleration Services Module Installation and Configuration Note
78-14459-03 Rev C0
Installing and Removing the VPN Module
Figure 8 Ejector Lever Closure in a Vertical Slot Chassis
Verifying the Installation
Enter the show module [mod-num | all] command to verify that the system acknowledges the new VPN
module and has brought it online.
This example shows the output of the show module command:
Router# show module
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 2 Catalyst 6000 supervisor 2 (Active) WS-X6K-S2U-MSFC2 SAD055106AH
2 16 SFM-capable 16 port 1000mb GBIC WS-X6516-GBIC SAD0546024C
4 48 SFM-capable 48-port 10/100 Mbps RJ45 WS-X6548-RJ-45 SAD060904PU
5 2 IPSec VPN Accelerator WS-SVC-IPSEC-1 SAD0636025E
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
1 0002.7e38.6c4c to 0002.7e38.6c4d 3.2 6.1(3) 6.2(2.107) Ok
2 0002.7ee0.28c0 to 0002.7ee0.28cf 3.0 6.1(3) 6.2(2.107) Ok
4 0001.63d6.94da to 0001.63d6.9509 4.2 6.3(1) 6.2(2.107) Ok
5 0060.0217.0000 to 0060.0217.0000 1.0 7.2(0.74-Eng 6.2(2.107) Ok
Mod Sub-Module Model Serial Hw Status
--- --------------------------- --------------- --------------- ------- -------
1 Policy Feature Card 2 WS-F6K-PFC2 SAD055200K7 3.0 Ok
1 Cat6k MSFC 2 daughterboard WS-F6K-MSFC2 SAD055107JD 2.0 Ok
Router#
FAN
STATUS
SELECT
NEXT
24 PORT 100FX
WS-X6224
STATUS
ACTIVE
SUPERVISOR2
WS-X6K-SUP2-2GE
STATUS
SYSTEM
CONSOLE
PW
R MGMT
RESET
CONSOLE
CONSOLE
PORT
MODE
PCMCIA EJECT
PORT 1
PORT 2
Switch Load
100%
1%
SUPERVISOR2
WS-X6K-SUP2-2GE
STATUS
SYSTEM
CONSOLE
PWR MGMT
RESET
CONSOLE
CONSOLE
PORT
MODE
PCMCIA
EJECT
PORT 1
PORT 2
Switch Load
100%
1%
63587
All ejector levers flush
with module faceplate