Specifications

2-714
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-02
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
switchport mode
Examples This example shows how to configure a port for access mode:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# switchport mode access
This example shows how set the port to dynamic desirable mode:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# switchport mode dynamic desirable
This example shows how to configure a port for trunk mode:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# switchport mode trunk
This example shows how to configure a port as an IEEE 802.1Q tunnel port:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# switchport mode dot1q-tunnel
You can verify your settings by entering the show interfaces interface-id switchport privileged EXEC
command and examining information in the Administrative Mode and Operational Mode rows.
Related Commands Command Description
show interfaces switchport Displays the administrative and operational status of a switching
(nonrouting) port, including port blocking and port protection
settings.
switchport access Configures a port as a static-access or dynamic-access port.
switchport trunk Configures the trunk characteristics when an interface is in trunking
mode.