Specifications

2-342
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-02
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
permit (IPv6 access-list configuration)
Examples This example configures two IPv6 access lists named OUTBOUND and INBOUND and applies both
access lists to outbound and inbound traffic on a Layer 3 interface. The first and second permit entries
in the OUTBOUND list permit all TCP and UDP packets from network 2001:ODB8:0300:0201::/64 to
leave the interface. The deny entry in the OUTBOUND list prevents all packets from the network
FE80:0:0:0201::/64 (packets that have the link-local prefix FE80:0:0:0201 as the first 64 bits of their
source IPv6 address) from leaving the interface. The third permit entry in the OUTBOUND list permits
all ICMP packets to leave the interface.
The permit entry in the INBOUND list permits all ICMP packets to enter the interface.
Switch(config)#ipv6 access-list OUTBOUND
Switch(config-ipv6-acl)# permit tcp 2001:0DB8:0300:0201::/64 any
Switch(config-ipv6-acl)# permit udp 2001:0DB8:0300:0201::/64 any
Switch(config-ipv6-acl)# deny FE80:0:0:0201::/64 any
Switch(config-ipv6-acl)# permit icmp any any
Switch(config-ipv6-acl)# exit
Switch(config)#ipv6 access-list INBOUND
Switch(config-ipv6-acl)# permit icmp any any
Switch(config-ipv6-acl)# exit
Switch(config)# interface gigabitethernet1/0/3
Switch(config-if)# no switchport
Switch(config-if)# ipv6 address 2001::/64 eui-64
Switch(config-if)# ipv6 traffic-filter OUTBOUND out
Switch(config-if)# ipv6 traffic-filter INBOUND in
Note Given that a permit any any statement is not included as the last entry in the OUTBOUND or the
INBOUND access list, only TCP, UDP, and ICMP packets are permitted out of and into the interface (the
implicit deny-all condition at the end of the access list denies all other packet types on the interface).
Related Commands
parameter-problem port-unreachable
reassembly-timeout renum-command
renum-result renum-seq-number
router-advertisement router-renumbering
router-solicitation time-exceeded
unreachable
Command Description
ipv6 access-list Defines an IPv6 access list and enters IPv6 access list configuration mode.
ipv6 traffic-filter Filters incoming or outgoing IPv6 traffic on an interface.
deny (IPv6 access-list
configuration)
Sets deny conditions for an IPv6 access list.
show ipv6 access-list Displays the contents of all current IPv6 access lists.