Datasheet

slots
WS-
X5410 9
GBIC
module
slots
1
Category 3 UTP cable can transmit data at speeds of up to 10 Mbps and therefore is only used for 10 Mbps
network devices. Catalyst 5000 10Base-T telco switching modules can use Category 3 cable, but Category 5
cable is required for all other 10/100 Base-TX switching modules.
2
LX/LH GBICs require a mode-conditioning patch cord between the GBIC and MMF. Refer to the Mode-
Conditioning Patch Cord section of the document Connector and Cable Specifications for more
information.
Catalyst 4500/4000 Switch Connectors and Cables
Refer to Catalyst 4500 Series Module Installation Guide - Module Overview and Specifications for the
detailed specification for the Catalyst 4500 switching modules.
Refer to Catalyst 4000 Switching Modules for the detailed specification for the Catalyst 4000 switching
modules.
Catalyst 3750 Connectors and Cables
Identify the switch chassis part number. Use this table in order to match up the part number with the type of
connector and cable used.
Note: The Catalyst 3750 switch ships with a 0.5-meter StackWise cable that you can use in order to connect
the StackWise ports on the rear panel. You can also order these StackWise cables from your Cisco sales
representative:
• CAB-STACK-50CM= (0.5-meter cable)
• CAB-STACK-1M= (1-meter cable)
• CAB-STACK-3M= (3-meter cable)
Part Number
Connector
Type
Cable
Type
Cable/Connector
Specifications
RJ-45 (for
10/100
ports)
Category 5,
5e, or 6
UTP cable
WS-C3750-
24TS WS-
C3750-48TS 24
or 48 10/100
Ethernet ports
and 2 or 4 SFP
module slots
SFP: LC
fiber-optic
(for
1000Base-
SX/LX) or
RJ-45 (for
1000Base-T)
SFP:
SMF/MMF
fiber-optic,
or Cat5, 5e,
or 6
Catalyst 3750
Hardware Guide