Installation guide

8
Cisco Catalyst 6500 Series Application-Oriented Networking Module Installation Note
78-16749-01
Environmental and System Requirements
Table 1 describes the Status LED operation.
Environmental and System Requirements
This section describes the environmental and system requirements for the AON module:
• Environmental Requirements, page 9
• System Requirements, page 9
• Memory Requirements, page 9
• Hardware Supported, page 9
• Power Supply, page 9
• Software Requirements, page 10
• Installing the Module, page 10
Table 1 AON Module LEDs
LED Color Description
Status Off • The module is waiting for the supervisor engine to provide power.
• The module is not online.
• The module is not receiving power, which could be caused by the following:
– Power is not available to the AON module.
– The module temperature is over the limit
1
.
1. Enter the show environment temperature mod command to display the temperature of each of the four sensors on the AON
module.
Red • The module is released from reset by the supervisor engine and is booting.
• If the boot code fails to run, the LED stays red after power up.
Orange • The module is initializing hardware or communicating with the supervisor
engine.
• A fault occurred during the initialization sequence.
• The module has failed to download its Field Programmable Gate Arrays (FPGA)
image on power up but continues with the remainder of the initialization
sequence and provides the module online status from the supervisor engine.
• The module has not received module online status from the supervisor engine.
This problem could be caused by the supervisor engine detecting a failure in an
internal loopback test that it issued to the AON module.
Green • The module is operational; the supervisor engine has provided module online
status.
Green
to
orange
• The module is disabled through the supervisor engine CLI
2
using the set module
disable mod command.
2. CLI = command-line interface.