Installation guide

20
Cisco Catalyst 6500 Series Application-Oriented Networking Module Installation Note
78-16749-01
Related Documentation
To understand the Cisco IOS command-line interface and Cisco IOS command modes, refer to
Chapter 2, “Command-Line Interfaces,” in the Catalyst 6500 Series Switch Cisco IOS Software
Configuration Guide.
To understand the Catalyst operating system command-line interface and Catalyst operating system
command modes, refer to Chapter 2, “Command-Line Interfaces,” in the Catalyst 6500 Series Switch
Configuration Guide.
You configure the module using the session command.
You can session into the module from the switch console and configure the module. The session is a
Telnet interface through the Ethernet out-of-band channel (EOBC) of the switch backplane.
Related Documentation
For more detailed installation and configuration information for the AON module, refer to the following
publications:
• Release Notes for Cisco Application-Oriented Networking
• AON Installation and Administration Guide
• AON Development Studio User
• Regulatory Compliance and Safety Information for the Catalyst 6500 Series Switches
Translated Safety Warnings
Warning Invisible laser radiation present. Statement 1016
Waarschuwing
Onzichtbare laserstraling aanwezig.
Varoitus
Näkymättömiä lasersäteitä.
Attention
Rayonnement laser actif mais invisible.
Warnung
Unsichtbare Laserstrahlung.
Avvertenza
Radiazione laser invisibile.
Advarsel
Usynlig laserstråling.
Aviso
Radiação laser invisível presente.
¡Advertencia!
Existe radiación láser invisible.
Varning!
Nu pågående osynlig laserstrålning.