Installation guide

14
Cisco Catalyst 6500 Series Application-Oriented Networking Module Installation Note
78-16749-01
Installing the Module
Figure 2 Positioning the Module in a Horizontal Slot Chassis
Step 6 Depending on the orientation of the slots in the chassis (horizontal or vertical), perform one of the
following sets of substeps:
Horizontal slots
a. Position the module in the slot. Make sure that you align the sides of the module carrier with the slot
guides on each side of the slot. (See Figure 2.)
b. Carefully slide the module into the slot until the EMI gasket along the top edge of the module makes
contact with the module in the slot above it and both ejector levers have closed to approximately
45 degrees with respect to the module faceplate. (See Figure 3.)
58569
INPUT
OK
FAN
OK
OUTPUT
FAIL
o
INPUT
OK
FAN
OK
OUTPUT
FAIL
o
1
2
3
FAN
STATUS
4
5
6
SUPERVISOR2
WS-X6K-SUP2-2GE
STATUS
SYSTEM
CONSOLE
PWR MGMT
RESET
CONSOLE
CONSOLE
PORT
MODE
PCMCIA EJECT
PORT 1
PORT 2
Switch Load
100%
1%
24 PORT 100FX
WS-X6224
SELECT
NEXT
EMI gasket
EMI gasket
Insert module
between slot guides
Ejector lever fully
extended
STATUS
ACTIVE
4
3
5
5
4
6
6
SWITCH FABRIC MDL
WS-C6500-SFM
STATUS
ACTIVE
SUPERVISOR2
WS-X6K-SUP2-2GE
STATUS
SYSTEM
CONSOLE
PWR MGMT
RESET
CONSOLE
CONSOLE
PORT
MODE
PCMCIA EJECT
PORT 1
PORT 2
Switch Load
100%
1%