Datasheet

© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 24 of 37
Maximum: Statistical maximum to account for variation in production
Relative Humidity
5% to 95%, noncondensing
Storage Environment
Temperature: -40 C' to 70 C'
Altitude: 15,000 ft
Vibration
Operating: 0.41Grms from 3 to 500Hz with spectral break points of 0.0005 G2/Hz at 10Hz and
200Hz 5dB/octave roll off at each end.
Nonoperating: 1.12Grms from 3 to 500Hz with spectral break points of 0.0065 G2/Hz at 10Hz
and 100Hz 5dB/octave roll off at each end.
Shock
Operating: 30G, 2ms Half sine
Nonoperating: 55G, 10ms Trapezoid
Note: GLC-GE-100FX and GLC-T SFPs are not supported for NEBS short-term operation.
Connectors and LED Indicators for Cisco Catalyst 3750-X and 3560X Series
Table 12 shows connectors and LED indicators.
Table 12. Connectors and LED Indicators
Connectors and
Cabling
●
1000BASE-T ports: RJ-45 connectors, 2-pair Cat-5E UTP cabling
●
1000BASE-T SFP-based ports: RJ-45 connectors, 2-pair Cat-5E UTP cabling
●
100BASE-FX, 1000BASE-SX, -LX/LH, -ZX, -BX10, DWDM and CWDM SFP Transceivers: LC fiber connectors (single-
mode or multimode fiber)
●
10GBASE-SR, LR, LRM, CX1 (v02 or higher) SFP+ Transceivers: LC fiber connectors (single-mode or multimode
fiber)
●
Cisco StackWise stacking ports: copper-based Cisco StackWise cabling
●
Cisco StackPower: Cisco Proprietary Power Stacking cables
●
Ethernet Management port: RJ-45 connectors, 2-pair Cat-5 UTP cabling
●
Management console port: RJ-45-to-DB9 cable for PC connections
Power Connectors
●
Customers can provide power to a switch by using either the internal power supply or the Cisco XPS 2200.
The connectors are located at the back of the switch
●
Internal power supply connector: The internal power supply is an autoranging unit. The internal power supply supports
input voltages between 100 and 240VAC. Use the supplied AC power cord to connect the AC power connector to an
AC power outlet
Management and Standards Support for Cisco Catalyst 3750-X and 3560-X Series Switches
Table 13 shows management and standards support for the Cisco Catalyst 3750-X and 3560-X Series.
Table 13. Management and Standards Support for the Cisco Catalyst 3750-X and 3560-X Series
Description
Specification
Management
BRIDGE-MIB
CISCO-CDP-MIB
CISCO-CLUSTER-MIB
CISCO-CONFIG-MAN-MIB
CISCO-ENTITY-FRU-CONTROL-MIB
CISCO-ENVMON-MIB
CISCO-FLASH-MIB
CISCO-FTP-CLIENT-MIB
CISCO-HSRP-MIB
CISCO-HSRP-EXT-MIB
CISCO-IGMP-FILTER-MIB
CISCO-IMAGE-MIB
CISCO-IP-STAT-MIB
CISCO-L2L3-INTERFACE-CONFIG-MIB
CISCO-POE-EXTENSIONS-MIB
CISCO-MAC-NOTIFICATION-MIB
CISCO-VTP-MIB
ENTITY-MIB
ETHERLIKE-MIB
IF-MIB
IGMP-MIB
IPMROUTE-MIB
OLD-CISCO-CHASSIS-MIB
OLD-CISCO-FLASH-MIB
OLD-CISCO-INTERFACES-MIB
OLD-CISCO-IP-MIB
OLD-CISCO-SYS-MIB
OLD-CISCO-TCP-MIB
OLD-CISCO-TS-MIB
OSPF-MIB (RFC 1253)
PIM-MIB
RFC1213-MIB