User Manual

7
The Express Setup page appears. If it does not appear, see the “In Case of Difficulty” section on page 18 for help.
Step 10
Enter this information in the Network Settings fields:
• In the Management Interface (VLAN ID) field, the default is 1. Enter a different VLAN ID only if you want to
change the management interface through which you manage the switch. The VLAN ID range is 1 to 1001.
• In the IP Address field, enter the IP address of the switch. In the IP Subnet Mask field, click the drop-down
arrow, and select an IP Subnet Mask.
• In the Default Gateway field, enter the IP address for the default gateway (router).
• Enter your password in the Switch Password field. The password can be from 1 to 25 alphanumeric characters,
can start with a number, is case sensitive, allows embedded spaces, but does not allow spaces at the beginning
or end.
• In the Confirm Switch Password field, enter your password again.
Step 11
(Optional) You can enter the Optional Settings information now or enter it later by using the device manager
interface:
• In the Host Name field, enter a name for the switch. The host name is limited to 31 characters. Do not use
embedded spaces.
• Enter the date, time, and time zone information in the System Date, System Time, and Time Zone fields. Click
Enable to enable daylight saving time.
Step 12
(Optional) Click the Advanced Settings tab on the Express Setup window, and enter the advanced settings now or
enter them later by using the device manager interface.