Installation guide

3-23
Catalyst 3550 Multilayer Switch Hardware Installation Guide
78-11358-06
Chapter 3 Switch Installation
Installing the Optional Ground Kit
Step 4 Using a Panduit crimping tool, crimp the ground lug to the 6-gauge wire. (See
Figure C-2 on page C-3.)
Step 5 Use the two number-10-32 screws to attach the ground lug and wire assembly to
the switch rear panel RPS connector cover, as shown in Figure 3-18.
Step 6 Using a ratcheting torque screwdriver, torque each ground-lug screw to 15 lbf-in.
(240 ozf-in.)
Figure 3-18 Torquing Ground-Lug Screws on the Switch
Torque to 15 lbf-in.
93286
100-240V~
5-3A
50/60Hz
DC OUTPUT 1
C
O
N
S
O
L
E