Installation guide

Appendix D Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
D-8
Catalyst 3550 Multilayer Switch Hardware Installation Guide
78-11358-06
interface FastEthernet0/1
!
interface FastEthernet0/2
interface FastEthernet0/3
!
...<output abbreviated>
!
interface GigabitEthernet0/10
!
end
Step 10 These choices appear:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to use the configuration the next time the switch reboots, save it in
NVRAM by selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
After you complete the setup program, the switch can run the default
configuration that you created. If you want to change this configuration or want
to perform other management tasks, use one of these tools:
• CLI
• CMS from your browser
To use the CLI, enter commands at the Switch> prompt through the console port
or through the network by using Telnet. For configuration information, refer to the
switch software configuration guide or the switch command reference.
To use CMS, refer to the software configuration guide.