User guide
Wireless-G Broadband Router
23
Instant Wireless
®
Series
Automatic Configuration - DHCP
If you are connecting through DHCP
or a dynamic IP address from your
ISP, perform these steps:
A. Keep the default setting,
Automatic Configuration -
DHCP, as the Configuration
Type.
B. Click the Apply button to save the
setting, or click the Cancel button to
clear the setting and start over.
When you are finished, proceed to
step 6.
Static (or Fixed) IP Address
If you are connecting through a
static or fixed IP address from
your ISP, perform these steps:
A. Select Static IP as the
Configuration Type.
B. Enter the Internet IP
Address.
C. Enter the Subnet Mask.
D. Enter the Default Gateway.
E. Enter the DNS in the 1, 2,
and/or 3 fields. You need to
enter at least one DNS
address.
F. Click the Apply button to save the settings, or click the Cancel button to clear
the settings and start over. When you are finished, proceed to step 6.
22
PPPoE
If your DSL provider says that
you are connecting through
PPPoE (you use a user name and
password to access the Internet),
perform these steps:
A. Select PPPoE as the
Configuration Type.
B. Enter the User Name.
C. Enter the Password.
D. Click the Apply button to save
the settings, or click the Cancel
button to clear the settings and
start over. When you are fin-
ished, proceed to step 6.
PPTP
PPTP is a service used in Europe
only. If you are using a PPTP con-
nection, check with your ISP for
the necessary setup information.
After you have entered your setup
information, click the Apply button
to save the settings, or click the
Cancel button to clear the settings
and start over. When you are fin-
ished, proceed to step 6.
Figure 5-5
Figure 5-6
Important: If you enable PPPoE, remember to remove any PPPoE
applications already installed on any of your PCs.
Figure 5-3
Figure 5-4