User guide

Model No.
K For Windows 2000 users, a
screen stating that a digital
signature was not found may
appear. This software has been
tested and found to work
properly with Windows 2000.
Click Yes to continue the
installation.
L After the files have been
successfully copied, the
Congratulations screen will
appear. Click Exit.
If you want to manually enter
the WEP key, leave the
Passphrase field blank and
enter the WEP key in the WEP
Key field.
Then click Next.
H If your network uses WPA
Personal, select TKIP or AES
Encryption and enter a
Passphrase of 8-63 characters.
Click Next.
I If your network uses WPA2
Personal, enter a Passphrase
of 8-63 characters. Click Next.
J The Setup Wizard will ask you to
review your settings before it
starts to copy files. Click Next to
save these settings, or click
Back to change any settings.
D After the Adapter is set firmly in
place, secure its fastening tab
to your PC’s chassis with a
mounting screw. Then close
your PC case.
E Attach the external antenna to
the Adapter’s antenna port and
position it straight up.
F Power on your desktop PC.
G For Windows 2000 users, a
screen stating that a digital
signature was not found may
appear. The Adapter has been
tested and found to work
properly with Windows 2000.
Click Yes.
H After the Adapter is installed, the
Wireless Network Monitor icon
will appear in the system
tray at the bottom right-
hand corner of your
screen.
Congratulations! The installation of
the Wireless-G PCI Adapter with
SpeedBooster is complete.
2
K
For additional information or troubleshooting
help, refer to the User Guide on the Setup CD-
ROM. You can also call or e-mail for further
support.
24-hour Technical Support
800-326-7114
(toll-free from US or Canada)
E-mail Support
[e-mail]
Website
http://www.linksys.com or
http://support.linksys.com
RMA (Return Merchandise Authorization)
http://www.linksys.com/support
FTP Site
ftp://ftp.linksys.com
Sales Information
800-546-5797 (800-LINKSYS)
A Division of Cisco Systems, Inc.
®
Linksys is a registered trademark or trademark of
Cisco Systems, Inc. and/or its affiliates in the U.S.
and certain other countries. Copyright © 2005
Cisco Systems, Inc. All rights reserved.
WMP54GS-QI-50215 BW
J
L
C
E
H
I
NOTE: Double-click the icon if you want
to check the link information, search for
available wireless networks, or make
additional configuration changes.
2
Install the Adapter
A Power off your desktop PC.
B Open your PC case, and
locate an available PCI slot on
the motherboard. Check with
your computer manufacturer
for instructions.
C Slide the Adapter into the PCI
slot. Make sure that all of its pins
are touching the slot’s
contacts. You may have to
apply a bit of pressure to slide
the Adapter all the way in.