Product specifications

Note When a new SSID gets created the system automatically sets the type of the WLAN to Guest from the
three available options – Data, Voice, Guest. You can also demonstrate that the new SSIDs and VLANs were created
successfully on the system as shown below.
STEP 9. DHCP services are not available on the Wireless controller so we will reserve to using the DHCP server on the UC500 to
assign IP addresses to the wireless APs and wireless clients After the WLANs and VLANs have been created and
configured verify or configure DHCP server on the UC500 in the <Configure><Routing> < DHCP Server> tab. Verify
that DHCP Pools and DHCP Exclusions are created and configured properly on the UC520 for each VLAN previously
configured.
STEP 10. Next move on the Monitor Tab and see some of the options there. Under Monitor>Reports you can see all wireless
Radios (APs) and wireless clients on the network.
© 2008 Cisco Systems, Inc. All rights reserved.
Important notices, privacy statements, and trademarks of Cisco Systems, Inc. can be found on cisco.com.
Page 28 of 95