User Manual

Configuring the Cisco WAP4410N Wireless-N Access Point
Wireless
WAP4410N Wireless-N Access Point with Power Over Internet Administration Guide 33
6
Configuring WPA-Enterprise
The WPA-Enterprise mode features WPA used in coordination with a RADIUS
server for client authentication.
!
CAUTION Use this mode only when a RADIUS server is connected to the access point.
To enable wireless WPA-Enterprise security, follow these steps:
STEP 1 Click Wireless > Security.
STEP 2 From the Security Mode drop-down menu, select WPA-Enterprise.
STEP 3 To enable wireless isolation within the SSID, click Enabled.
STEP 4 Provide the following information:
• Primary/Backup RADIUS Server—Enter the IP address of the RADIUS
server. The Backup Radius server is used only if the primary server is
unavailable.
• Primary/Backup RADIUS Server Port—Enter the port number used by
the RADIUS server. The default is 1812. The backup Radius server is used
only if the primary server is unavailable.
• Primary/Backup Shared Secret—Enter the Shared Secret key used by the
access point and RADIUS server. The backup Radius server is used only if
the primary server is unavailable.
• WPA Algorithms—WPA offers two encryption methods, TKIP and AES for
data encryption. Select one of these algorithms from the drop-down menu.
The default is TKIP.
• Key Renewal Timeout—Enter a key renewal timeout period, which
instructs the access point how often it should change the encryption keys.
The default is 3600 seconds.
STEP 5 Click Save.