Operation Manual

Configuring LED Patterns

Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 209

u=on/off/on/off/etc.

This is a user-defined blinking pattern used only when p = ud. It consists of up to 4

pairs of on/off duration in seconds with up to 2 decimal places; each value is

separated by a forward slash (/).

LED Script Examples

c=r;p=sb

Color is red and pattern is slow blink.

c=o

LED is off.

c=g

Color is green and pattern is steady on (default).

c=a;p=ud;u=.1/.1/.1/.1/.1/.9

Color is amber (orange) and the blink pattern is: 100ms on, 100ms off, 100ms on,

100ms off, 100ms on, 900ms off

LED Pattern

The administrator can also specify a different color and pattern for each of the

following states of the call appearance.

• Idle: This call appearance is not in use. It can be used to make outbound call

on this phone

• Local Seized: This call appearance has been seized by this phone to

prepare for an outbound call

• Local Progressing: This phone is making an outbound call that is

progressing

• Local Active: This phone is engaged in a connected call on this call

appearance

• Local Ringing: This phone is ringing for an incoming call on this call

appearance

• Local Held: This phone has placed this call appearance on hold

Downloaded from www.Manualslib.com manuals search engine