Troubleshooting guide

1-17
Cisco Wide Area Application Services Configuration Guide
OL-26579-01
Chapter 1 Planning Your WAAS Network
WAAS Devices and Device Mode
wae(config)# exit
wae# copy run start
wae# reload
Proceed with reload?[confirm]yes
Proceed with clean WCCP shutdown?[confirm]yes
WCCP clean shutdown initiated
Waiting for shutdown ok (1 seconds) . Press ^C to skip waiting
WCCP clean shutdown wait time expired
Shutting down all services, will timeout in 15 minutes.
reload in progress ..
Step 4 Log into the WAE after it finished rebooting.
AppNav Controller
wae login: admin
Password:
System Initialization Finished.
wae#
Step 5 Reenable CMS services.
wae# config
wae(config)# cms enable
Registering WAAS AppNav Controller...
Sending device registration request to Central Manager with address 10.43.65.50
Please wait, initializing CMS tables
Successfully initialized CMS tables
Registration complete.
Please preserve running configuration using 'copy running-config startup-config'.
Otherwise management service will not be started on reload and node will be shown
'offline' in WAAS Central Manager UI.
management services enabled
Step 6 Save the configuration.
wae(config)# exit
wae# copy run start
Note While using the AppNav IOM on the WAVE devices (7571 and 8541 only); and when the device mode
is AppNav Controller, the total TCP connection capacity for optimized traffic is reduced. This affects
only the local device hosting the AppNav Controller and not the connection capacity or the throughput
of the AppNav Controller itself. There is no impact on any other device that is a part of the AppNav
cluster.
The table shows the reduced number of connections on the AppNav Controller.
Platform Application Accelerator Appnav-mode
7571 60,000 50,000
8541 1,50,000 1,40,000