Troubleshooting guide

1-25
Cisco Wide Area Application Services Configuration Guide
OL-26579-01
Chapter 1 Configuring SNMP Monitoring
Configuring SNMP Trap Source Settings
Step 1 From the WAAS Central Manager menu, choose Devices > device-name. (This setting is not supported
from device groups.)
Step 2 Choose Configure > Monitoring > SNMP > Trap Source. The SNMP Trap Source Settings window
appears.
Step 3 From the Trap Source drop-down list, choose the interface to be used as the trap source. From the
available physical, standby, and port-channel interfaces, only those with IP addresses are shown in the
list. For vWAAS devices, virtual interfaces with assigned IP addresses are shown in the list.
Note An interface assigned as a trap source cannot be removed until it is unassigned as a trap source.
Step 4 Click Submit.
To configure SNMP trap source settings from the CLI, you can use the snmp-server trap-source global
configuration command.