Troubleshooting guide

1-11
Cisco Wide Area Application Services Configuration Guide
OL-26579-01
Chapter 1 Configuring SNMP Monitoring
About SNMP
SNMP-COMMUNITY-MIB
This MIB is documented in RFC 2576.
SNMP-FRAMEWORK-MIB
This MIB is documented in RFC 2571.
SNMP-NOTIFICATION-MIB
This MIB is documented in RFC 3413.
SNMP-TARGET-MIB
This MIB is documented in RFC 3413.
SNMP-USM-MIB
This MIB is documented in RFC 2574.
SNMPv2-MIB
This MIB is documented in RFC 1907. WAAS supports the following notifications from this MIB:
• coldStart
• linkUp
• linkDown
• authenticationFailure
SNMP-VACM-MIB
This MIB is documented in RFC 2575.
Downloading MIB Files
You can download the MIB files for most of the MIBS that are supported by a device that is running the
WAAS software from the following Cisco FTP site:
ftp://ftp.cisco.com/pub/mibs/v2
You can download the RFC1213-MIB file (for MIB-II) from the following Cisco FTP site:
ftp://ftp.cisco.com/pub/mibs/v1
The MIB objects that are defined in each MIB are described in the MIB files at the above FTP sites and
are self-explanatory.
Enabling the SNMP Agent on a WAAS Device
By default, the SNMP agent on WAAS devices is disabled and an SNMP community string is not
defined. The SNMP community string is used as a password for authentication when accessing the
SNMP agent on a WAAS device. To be authenticated, the Community Name field of any SNMP message
sent to the WAAS device must match the SNMP community string defined on the WAAS device.