Troubleshooting guide

1-8
Cisco Wide Area Application Services Configuration Guide
OL-26579-01
Chapter 1 Monitoring and Troubleshooting Your WAAS Network
Viewing Device Information
Device Dashboard Window
The Device Dashboard window provides detailed information about a WAAS device such as the device
model, IP address, interception method, and device-specific charts. (See Figure 1-5.)
To access the Device Dashboard window, choose Devices > device-name.
Table 1-3 Service Descriptions
Service Description
CM (Primary) The device has been enabled as the primary WAAS Central Manager. For
information on primary and standby Central Manager devices, see the
“Converting a Standby Central Manager to a Primary Central Manager” section
on page 1-28.
CM (Standby) The device has been enabled as a standby WAAS Central Manager. For
information on primary and standby Central Manager devices, see the
“Converting a Standby Central Manager to a Primary Central Manager” section
on page 1-28.
Application
Accelerator
The device has been enabled as an application accelerator.
AppNav Controller The device has been enabled as an AppNav Controller.
Replication
Accelerator
The device has been enabled as a replication accelerator. (Supported only on
4.0.19 or later 4.0.x devices.)
WAAS Express The device is an IOS router with the WAAS Express functionality enabled.
Table 1-4 License Status Descriptions
License Status Description
Not Active No license is installed or the first configuration synchronization has not yet
happened.
Transport, Enterprise,
Video, VB
The listed licenses are installed.
Active A WAAS Express device is registered but the first configuration
synchronization has not yet happened.
Permanent A WAAS Express device has a permanent license installed.
Evaluation, Expires in
X weeks Y days
A WAAS Express device has an evaluation license installed and it expires after
the indicated period.
Expired A WAAS Express device has an expired evaluation license. A permanent
license must be obtained for this device to operate.
N/A The license status is not applicable because the device version is 4.0.