Troubleshooting guide

1-4
Cisco Wide Area Application Services Configuration Guide
OL-26579-01
Chapter 1 Configuring the Network Analysis Module
Configuring the NAM
The Setup window appears. This window allows you to configure the NAM IP address and accounts.
Figure 1-1 Setup Window
Step 2 In the NAM Server area, provide the following information:
– Choose either HTTP or HTTPS depending on the access that was configured during the
installation of NAM.
– Enter the hostname of the NAM server.
– Enter the IP address of the NAM server.
To set up a sites or sites on the NAM module, perform the following steps:
Step 3 To use the pre-configured login credentials to access the NAM server, select the Use Default credentials
option. Proceed to Step 8.
The following preconfigured login credentials are specified in the Central Manager:
• Configuration user:
– Username—admin
– Password—admin
• MonitorView user:
– Username—waasro
– Password—waasrao
These credentials work only if you configured the NAM with them explicitly after installation or you
installed the NAM virtual blade with these credentials for POC deployments.
Step 4 In the NAM Configuration User field, enter the username of an existing configuration user on the NAM
server.
Step 5 In the NAM Configuration Password field, enter the password of the configuration user that was
specified in Step 3.