Troubleshooting guide

1-53
Cisco Wide Area Application Services Configuration Guide
OL-26579-01
Chapter 1 Configuring Application Acceleration
Creating a New Traffic Optimization Policy
d. Click the Add Match Condition icon to enter the conditions. (See Figure 1-33.)
Note For a WAAS Express device, Protocol and EPM Custom UUID settings are not applicable.
Figure 1-33 Adding a New Match Condition Window
e.
Enter a value in one of the destination or source condition fields to create a condition for a specific
type of traffic.
For example, to match all traffic going to IP address 10.10.10.2, enter that IP address in the
Destination IP Address field.
Note To specify a range of IP addresses, enter a wildcard subnet mask in either the destination or
source IP Wildcard field.
f. Click OK. You return to creating a new policy in the Optimization Policy window.
Step 6 From the Action drop-down list, choose the action that your WAAS device should take on the defined
traffic. Table 1-5 describes each action.
Note For a WAAS Express device, only a subset of the actions are available. These include:
Passthrough, TFO Only, TFO with LZ, TFO with DRE, and TFO with DRE and LZ.