Troubleshooting guide

1-48
Cisco Wide Area Application Services Configuration Guide
OL-26579-01
Chapter 1 Configuring Application Acceleration
Enabling and Disabling the Global Optimization Features
Figure 1-30 SSL Accelerated Services—Advanced Window
Step 14
(Optional) In the SSL version field, choose the type of SSL protocol to use, or choose Inherited to use
the SSL protocol configured in global SSL settings. Choose SSL3 for the SSL version 3 protocol, choose
TLS1 for the Transport Layer Security version 1 protocol, or choose All to use both SSL3 and TLS1
SSL protocols.
Step 15 (Optional) In the Cipher List field, choose a list of cipher suites to be used for SSL acceleration between
the WAE device peers, or choose Inherited to use the cipher list configured in SSL global settings. For
more information, see the “Working with Cipher Lists” section on page 1-35.
Step 16 (Optional) To set the Online Certificate Status Protocol (OCSP) parameters for certificate revocation,
follow these steps:
a. To enable verification of client certificate check, check the Verify client certificate check box.
b. Check the Disable revocation check for this service check box to disable OCSP client certificate
revocation checking.
c. To enable verification of server certificate check, check the Verify server certificate check box.
d. Check the Disable revocation check for this service check box to disable OCSP server certificate
revocation checking.
Note If the server and client devices are using self-signed certificates and certificate verification is
enabled, WAAS devices will not be able to accelerate SSL traffic.